Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
59
4. Disconnect the connector cable, and remove two screws securing cutter unit, then
romove the Cutter unit.
Figure 4-103.
Cutter
Cable
Screw
C A U T I O N
When assembly, adjacent the cutter edge in the section department of
a sub platen like the following figure. (Do not part from the section too
much / not run on the convex part.)
Figure 4-104.
A D J U S T M E N T
R E Q U I R E D
When attach the cutter unit, perform the cutter position adjustment.
(Refer to “Cutter position adjustment 198.)
Cutter edge