Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
58
4.2.3.4 Removing the Cutter and Cutter unit
1. Remove the two screws (CP(W):M3x6) securing the carriage cover and remove the
carriage cover.
Figure 4-100.
NOTE:
n When remove the cutter blade, take the following steps 2 to 3.
n When remove the cutter unit, take the following steps 4.
2. Push down and hold the cutter lever then pull up the solenoid and rotate it to the arrow
direction.
Figure 4-101.
3. Pulling up the cutter from cutter unit.
Figure 4-102.
Carridge cover
Screw
Cutter
A D J U S T M E N T
R E Q U I R E D
Run the automatic cutting operation, after cutter unit attaches. The
cutter is released to the home position and cut it the form accurately.
Cutter lever
Solenoid
Cutter