Service manual

EPSON Stylus Pro 10000/10000CF Revision A

Disassembly & assembly Disassembly Flow

12. Disconnect three connector cable, while push down the upper side of the head board.

Figure 4-93.

13. Remove the screw of the upper side while holding down the compression spring that is

attached to the screw of the lower part with the finger such that the spring of the hinge

does not miss and not jump out, then remove the hinge, compression spring and holder.

Also remove the hinge on the right side.

Figure 4-94.

Figure 4-95.

C A U T I O N

There is the danger that damages the substrate and also cause the

contact defectiveness of the FFC cable, if it does not draw out the

connector cable after the upper side of the head substrate is held

down.

C A U T I O N

Do not forget that the compression spring and spring holder (the black

plastics) are attached with the lower part screw.

Hinge L

Spring holder

Screw (lower side)

Hinge RCompression spring