Service manual

EPSON Stylus Pro 10000/10000CF Revision A

Disassembly & assembly Disassembly Flow

5. Remove the Waste Ink Box by sliding it forward so the hooks on both sides release and

then pull up.

Figure 4-67. Waste Ink Box

6. Remove three screws on the ink tube clamp and remove it.

Figure 4-68. Disassembly of the Waste Ink Box

7. Remove the old Waste Ink Unit and dispose of them properly.

8. Insert new Waste Ink Unit, and re-install the Waste Ink Box in the printer.

Ink tube clamp

Screw

Waste Ink Unit

C H E C K

P O I N T

When replacing the Waste Ink Unit, prepare a vinyl bag beforehand

for disposal of the Pads.

A D J U S T M E N T

R E Q U I R E D

When replacing the Waste Ink Unit, the following adjustment

procedures are required. See “Maintenance Mode 2” on page 50.

n INIT. WASTE INK

n INIT. CLEANING

To reassemble the waste ink box and related parts, follow the above

steps in reverse order and make sure you keep the following in mind:

n The waste ink tubes should be inserted into the ink tube clamp.

n Make sure the tubes are not twisted or pinched.

Figure 4-69.

(Front side view)

Connect to the Creaning unit.

Connect to the flushing box.