Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
33
4.2.2 Circuit Board Removal
This section explains how to remove the Power Board, the HJFK / Dummy Board, the
C362MAIN Board, the CSIC Board, the C362DRV Board and the P/S Fan.
4.2.2.1 Power Board Removal
1. Remove the Rear Cover as described in “Rear Cover Removal” paragraph 4.2.1.7.
2. Remove the three cables connected to the Power Board as shown below.
Figure 4-41.
W A R N I N G
Unplug the AC power cable and wait at least five minutes before
removing the power board to make sure there is no residual power
left in the board’s condensers.
Table 4-2. Power Board Connectors
Connector # Pins Color Connection Notes
CN2 3 BIK/R/ORG C362DRV Board CN56
CN3 None
CN4 12
YEI/BRN/RED/
BIU/ORG/BIK
C362DRV Board CN40
CN2
CN4