Service manual

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
29
3. Remove front four white screws , then remove the Paper Guide L.
C A U T I O N
To avoid injury and paper guide L damage, make sure the protection
of drop with proper method.
Tape
Screw
When installing the Paper Guide L, make sure the five tabs at the top
end slide into the hole of “Sub platen”. Then secure with the screws.
Figure 4-31.
If just one of the tabs is not inserted properly, roll paper will most
likely still feed normally, but cut sheets might not.
Sub platen
Paper Guide L