Service manual

EPSON Stylus Pro 10000/10000CF Revision A

Disassembly & assembly Disassembly Flow

5. Opening I/C holder cover by pushing the central upper part (the cover latch location) of

it,then remove I/C holder cover with the hinge of the right and left.

6. Removing the E ring, then I/C holder cover and slowing-down gear are separated.

Figure 4-21.

4.2.1.7 Rear Cover Removal

1. From the rear, remove four white screws (CPS:M3x12) securing the optional interface

cover, and remove the optional interface cover.

Figure 4-23.

2. Removing (CBS: 1 M3x6) the screw fixing HJFK (Dummy) board, then extract HJFK

(Dummy) board.

Figure 4-24.

C H E C K

P O I N T

When installing the “I/C Holder Cover”, make sure the position of

cover latch and cover interlock are placed correctly with frame.

Figure 4-22.

I/C Holder Cover

Ering

Slow-down gear

Switch lever

Screw

Optional interface cover

HJFK board / Dummy board

Screw

HJFK board / Dummy board