Service manual

EPSON Stylus Pro 10000/10000CF Revision A

Disassembly & assembly Disassembly Flow

2. Remove the FFC cable from the connector and hook.

Figure 4-6. Panel Unit Removal 2/2

3. Remove nine screws then remove the panel board.

Figure 4-7.

rth

C H E C K

P O I N T

You may find it easy to remove the panel unit if you stand on the front

of the printer and use both hands to pull (squeeze) the panel towards

then lift up. (Refer the above figures and arrow directions. This way

you remove first the rear-side hook, then you can easily remove it.

Connector

Hook

FFC Cable

When replacing the panel board and FFC, make sure you push the

FFC cable slack inside and towards the rear of the printer to avoid

interfering with carriage movement.

When installing the panel unit, place the grounding plate under the R-

side cover then push and lock it to the R side cover.