Service manual

EPSON Stylus Pro 10000/10000CF Revision A

Disassembly & assembly Disassembly Flow

4.2.1 Removing the Housing

This sections describes the removal procedure for printer housing parts. See below for an

illustration of the housing parts.

Figure 4-3. Housing Part Diagram

4.2.1.1 Panel Unit Removal

1. Push the clips (Refer to Figure 4-5. ) on both sides of the panel unit and pull slightly

away from the R Side Cover.



Push it toward you.

Figure 4-4. Panel Unit Removal 1/2



Lift it up



Lift it up then turn over.

Figure 4-5.

(Front View)

(Rear View)

Roll Paper Cover

H Top Cover R Side Cover

Paper Guide L2

Front Cover

Paper Set Lever

Panel Unit

IC Holder Cover

Interface Cover

Paper Guide U

Rear Cover

Waste Ink Cover

Connector

Clip

Clips