Service manual

EPSON Stylus Pro 10000/10000CF Revision A

Disassembly & assembly

ummary

Figure 4-1. Directional View of the Printer

C A U T I O N

n When replacing connector wires, be careful to replace the entire

length of the wire exactly as you found it; rubbing against edges

or moving parts can cause noise in the wires.

n The cutter blade is very hard and can damage or scratch printer

parts, and it can also be chipped or damaged. Be careful when

handling or replacing the cutter.

n If you have to loosen a screw that has blue screw-lock applied to

its head, make sure you apply blue screw-lock again when

reassembling.

n When tight the screw that has no tightening torque value, secure

it not to make screw loosen.

C H E C K

P O I N T

n If you find it is necessary to perform service on a part not

described in this chapter, be sure to check the after-service parts

situation before beginning the service.

n If necessary (i.e. when transporting the printer) use the above

mentioned mode to drain ink, install the discharge cartridges (P/

N:1060627), and then perform an initial ink charge with the

fluid. Enter the transportation mode again to remove the fluid

(user can do) and then perform initial ink charge with ink.

n The directional instructions in this chapter are given as if viewing

the printer from the front. See the illustration below.

Top

Bottom

Rear

Front