Specifications

Using the Ethernet Card with Macintosh 5-3

Configuring the Ethernet Card Using EPSON Net!2 for

Macintosh

Use EPSON Net!2 for Macintosh to configure the Ethernet card as

described below.

Caution:

Once you make changes to the Ethernet card using EPSON Net!2,

wait until it registers the settings before turning off or sending data

to the printer.

1. Make AppleTalk active in the Chooser.

2. Connect the Ethernet card to the network and turn on the

printer.

3. From your hard disk, double-click the EPSON Net!2 icon.

4. Highlight the printer you want to configure from the list and

click Configuration.

Note:

❑ If you have connected more than one printer with the same type of

Ethernet card to the network, you can distinguish the cards by

their MAC (Media Access Control) addresses. To view a card’s

MAC address, press the status sheet button on the card for three

seconds. See Chapter 1 for details.

❑ If the IP address is set to the default IP address, the printer model

might not appear.

Chap5.fm Page 3 Friday, August 21, 1998 1:15 PM