Specifications

11-10 EPSON Status Monitor 2 (Windows Only)
Changing Status Monitor 2 Settings
You can change EPSON Status Monitor 2 settings as described below.
1. Open the Run dialog box from the Start menu or the Control
Panel depending on your system. Type the path to the directory
where you installed the Status Monitor, followed by Setup. Then
click OK.
When you have installed the program in directory ESM2 of
drive C, type C:\ESM2\SETUP.
Note:
If you installed the program in a directory other than ESM2, type the
path to the directory instead of ESM2.
2. Follow the instructions on the screen.
Note (Windows NT 3.51 and 4.0):
Users can individualize their own settings without affecting the settings
of other users.
Starting EPSON Status Monitor 2
From Windows 95, 98, and NT 4.0
Double-click the Status Monitor icon on the right side of the
taskbar.
Windows 95, Windows 98,
and Windows NT 4.0
Windows NT 3.51
Chap11.fm Page 10 Friday, August 21, 1998 1:50 PM