Specifications

Using EPSON Net!2 and the Ethernet Card Home Page 10-3
Time-out time:
Use this to set the time-out for communication with the Ethernet
card(s). You can choose a value between 3 and 99 seconds. (The
default value is 15 seconds.)
Note:
When the network is large and many Ethernet cards are used, a longer
time-out is recommended.
NetWare effective hops:
Set the number of hops you can take to get to the Ethernet card
when searching for printer information. All cards within this
number of hops are identified and listed in EPSON Net!2. You
can set the number of hops from 0 to 15. (The default value is 3.)
c
Caution:
Set the smallest value necessary for the number of hops. If you
set a large number of hops, many search packets are generated,
causing excess network traffic. If you use a dial-up router,
account faults may be caused by passing search packets through
the line.
Using Subnet Settings
Use these settings when you want to get the interface card’s
information for another segment on the network. See Chapter 3.
Item Explanation
Subnet Type the subnet address you want to search (0
to 255).
Subnet List box The interface cards in the subnet address you
added to the Subnet box are searched and are
listed on the EPSON Net!2 dialog box.
Add button Adds the subnet address to the Subnet List box.
Delete button Deletes the subnet address from the Subnet List
box by selecting the subnet address and then
clicking the Delete button.
Chap10.fm Page 3 Friday, August 21, 1998 11:32 AM