Specifications

EPSON EPL-N1600 Chapter 3 Troubleshooting
Rev. A 96
3.13 DAMAGED PRINTING
Problem Suspect Components
The printed paper is either
wrinkled, creased, or torn.
The followin
g
components are assosiated with
this specific problem. One or more of these
components ma
y
have failed partiall
y
or
completel
y
. If
y
ou can not isolate the problem
usin
g
this procedure, replace each components
listed below, one at a time, until the problem
disappears.
• Fuser Ass
y
.
• Paper Cassette
• Paper Path Rolls
Step Action and Question Yes No
1
PAPER FEED
• Are the paper cassettes installed
correctl
y
?
• Is the paper loaded into the
cassette correctl
y
?
Go to Step 2. Reload the
paper and re-
install the paper
cassette.
2
PAPER CONDITION
Is the paper damp?
Replace with
new, dr
y
paper.
Go to Step 3.
3
PAPER PATH
Inspect the entire paper path for an
y
ostructoion or contamination.
Is the paper path free of obstruction
or contamination?
Go to Step 4. Clean or
remove the
obstruction in
the paper path.
4
PAPER PATH ROLLS
Inspect all rolls alon
g
the paper path
for an
y
contamination, wear or
dama
g
e.
Are the paper path rolls free of
contamination, wear or dama
g
e?
Go to Step 5. Replace the
dama
g
ed or
worn rolls to
new one.
5
FUSER ASSY.
1. Remove the Fuser Ass
y
.
2. Inspect the surface of Roll Fuser
and Roll Press.
Are the surface of rolls free of dirt or
scracthes?
Go to Step 6. Clean or
replace the
rolls.
6
IMAGING CARTRIDGE
Install a new Ima
g
in
g
Cartrid
g
e.
Is the print ima
g
e normal?
Go to suspect
component.
Problem
solved.