Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-143
4.3.34 Roll Assembly Exit
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Roll Assembly Exit Out. (Section 4.3.27)
7. Remove the Fuser Assembly. (Section 4.3.31)
8. Turn the Fuser Assembly upside down.
9. Release (press down) the latch on the Bearin
g
-Exit Roll SP (ri
g
ht
bearin
g
) with the blade of a small screwdriver (1) and slide the
Bearin
g
off of the shaft.
10. Release the latch on the Gear-Exit with the blade of a small
screwdriver (2) and slide the Roll Assembly Exit to the ri
g
ht to
g
et
the left end of the shaft (left end of the shaft is partially cut flat) out of
the Bearin
g
-Exit Roll (left bearin
g
).
11. Slide the Roll Assembly Exit to the left to
g
et the ri
g
ht end of the
shaft out of the bearin
g
hole.
Figure 4-40. ‘Roll Assembly” Removal