Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-134
4.3.25 Sensor No Paper MBF
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Sprin
g
-Hold Rod, Stopper Rod, and
Sprin
g
Nip Pre-Re
g
istration (steps 6 and 7 of RRP 4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove the Roll Assembly MBF.(Section 4.3.21)
9. Remove the Holder Gear MBF. (Section 4.3.22)
10. Remove the Plate Assembly Bottom MBF. (Section 4.3.24)
11. Disconnect J236-2.
12. Squeeze to
g
ether the clips that are holdin
g
the Sensor No Paper
MBF to the bottom of the Frame Assembly MBF and remove the
Sensor No Paper MBF from the Frame to
g
ether with the Harness
Sensor MBF.
13. Disconnect J236-3 to remove the Harness Sensor MBF from the
Sensor No Paper MBF.
Figure 4-31. “Sensor No Paper MBF” Removal