Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-127
4.3.18 Roll Assembly Pinch Pre-Registration
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Pull the Lever Jam Clear off of the retainin
g
brackets (1).
7. Remove the Sprin
g
-Hold Rod, Stopper Rod, and Sprin
g
Nip Pre-
Re
g
istration (2).
8. Remove the Frame Assembly MBF.(Section 4.3.19)
9. Remove the C258MAIN Board.(Section 4.3.49)
10. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
11. Remove the PWBA Hotaru.(Section 4.3.48)
12. Remove the Actuator No Paper.(Section 4.3.8)
13. Remove the Drive Assembly-F/P.(Section 4.3.42)
14. Remove the Drive Assembly Main.(Section 4.3.43)
15. Remove the Sensor Toner if installed.
16. Remove the Kit Chute Re
g
istration Assembly. (Section 4.3.11)
17. Squeeze to
g
ether the latches of the Roll Assembly Pinch Pre-
re
g
istration (3) and take it out of the Frame (4).
Figure 4-24. “Roll Assembly Pinch Pre-Registration” Removal