Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-125
4.3.16 Solenoid Exchange
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the C258MAIN Board.(Section 4.3.49)
7. Remove the Shield Assembly Bottom (E). (Section 4.3.44)
8. Remove the two screws that secure the Solenoid Exchan
g
e
(Direction solenoid) to the Printer Frame.
9. Take the Solenoid out of the Frame, tiltin
g
the top of the Solenoid
away from the Frame while pushin
g
in the bottom end of the
Solenoid plun
g
er upward obliquely to disen
g
a
g
e the Solenoid
plun
g
er from the forked arm of the Chute Exchan
g
e.
Figure 4-22. “Solenoid Exchange” Removal
CHECK
PO INT
Position the SOLENOID EXCHANGE as to locate the
screw holes on your right.
Make sure to engage the solenoid plunger with a falk
arm of the CHUTE EXCHANGE while pushing up the
arm with your finger.