Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-122
4.3.13 Link Interlock Switch and Cam Interlock
Switch
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Sprin
g
-Hold Rod, Stopper Rod, and
Sprin
g
Nip Pre-Re
g
istration (steps 6 and 7 of RRP 4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove the C258MAIN Board.(Section 4.3.49)
9. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
10. Remove the PWBA Hotaru.(Section 4.3.48)
11. Remove the Chassis Assembly PS.(Section 4.3.46)
12. Remove the Drive Assembly-F/P.(Section 4.3.42)
13. Remove the Drive Assembly Main.(Section 4.3.43)
14. Remove the Sensor Toner if installed.
15. Remove the Roll Assembly Feed.(Section 4.3.7)
16. Remove the Actuator No paper.(Section 4.3.8)
17. Remove the Drive Assembly.(Section 4.3.3)
18. Remove the Kit Chute Re
g
istration Assembly. (Section 4.3.11)
19. Pull the Cam Interlock Switch off of the retainin
g
slots.
20. Press down the stopper tab on the Link Interlock Switch and slide
the Link Interlock Switch to the left out of the
g
uide on the Kit Chute
Re
g
istration Assembly Kit Chute Re
g
istration Assembly.
Figure 4-19. “Link Interlock Switch/Cam Interlock Switch”
Removal