Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-120
4.3.11 Kit Chute Registration Assembly
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the C258MAIN Board.(Section 4.3.49)
7. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
8. Remove the PWBA Hotaru.(Section 4.3.48)
9. Remove the Chassis Assembly PS.(Section 4.3.46)
10. Remove the Roll Assembly Feed.(Section 4.3.7)
11. Remove the Actuator No Paper.(Section 4.3.8)
12. Remove the Drive Assembly-F/P. (Section 4.3.42)
13. Remove the Drive Assembly Main. (Section 4.3.43)
14. Remove Lever Jam Clear, Sprin
g
-Hold Rod, Stopper Rod, and
Sprin
g
Nip Pre-Re
g
istration.
15. Remove the Frame Assembly MBF. (Section 4.3.19)
16. Remove the Drive Assembly.(Section 4.3.3)
17. Remove the Sensor Toner if installed.
18. Set the Printer Frame on its rear surface.
19. Press to
g
ether the hook of the Chute Rib and push up the Rib
upward (to the front).
20. Remove the five screws that secure the Kit Chute Re
g
istration
Assembly to the Printer Frame.
21. Pull a little the left side of the Kit Chute Re
g
istration Assembly and
hold on the air, then pull ri
g
ht side carefully with the Link Interlock
Switch skiddin
g
to the left, and finally take the Kit Chute Re
g
istration
Assembly out of the Printer Frame.
Figure 4-17. “Kit Chute Registration Assembly” Removal