Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-117
4.3.8 Actuator No Paper
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the C258MAIN Board.(Section 4.3.49)
7. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
8. Remove the PWBA Hotaru(Section 4.3.48)
9. Remove the Chassis Assembly PS. (Section 4.3.46)
10. Set the printer on the rear surface.
11. Remove the Roll Assembly Feed.
12. Press the Bearin
g
Feed away from the Roll Assembly Feed to pull
off the latches (1) at the bottom part of the Bearin
g
Feed. Then, tilt
the Bearin
g
Feed away from the shaft as far as it can
g
o, manipulate
it to disen
g
a
g
e the hook (2) at the bottom, and remove it.
13. Turn the Actuator No Paper around the shaft to line up the
g
roove in
the inside surface of the Actuator with a stopper projection on the
shaft (3), and slide the Actuator off of the shaft.
Figure 4-14. “Actuator No Ppaer” Removal