Specifications

EPSON EPL-N1600 Chapter 4 Disassembly and Assembly
Rev. A 4-113
4.3.4 Solenoid Feed
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E. (Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E.(Section 4.3)
6. Remove the C258MAIN Board. (Section 4.3.49)
7. Remove the Shield Assembly Bottom (E). (Section 4.3.44)
8. Remove the wire harness from the Drive Assembly front plate.
9. Remove the four screws that secure the Drive Assembly front plate
(2).
10. Squeeze to
g
ether the latch clips that retain the front plate and pull
the front plate away from the Drive Assembly
g
ears. After the front
plate becomes free of the
g
ear shafts, lift it up to make the inner arm
of the front plate clear the lar
g
e
g
ear (3).
11. Slide the lar
g
e
g
ear (3) off of the shaft so that you can access the
Solenoid Feed.
12. Disconnect J2341 (on the Solenoid Feed wire harness) from P234-1
(on the wire harness from the Sensor Assembly-Size 1,E).
13. Remove the screw that secures the Feed Solenoid and take the
Solenoid out of the Drive Assembly.
Figure 4-10. “Solenoid Feed” Removal