Service manual

Product Description
1-24
EPSON FX-880/FX-1180 Service Manual
Note that in the following table, factory settings are shown in bold.
Table 1-30. Default Settings (Mode 1)
Item Setting/Value
Skip over perforation
On, Off
Auto tear off
On, Off
Auto line feed
On, Off
Print Direction
Bi-d, Uni-d
I/F mode
Auto, Built-in Parallel, Optional Type-B
Auto I/F wait time
10 sec, 30 sec
Software
ESC/P, IBM 2380/2381 Plus
0 slash
O, Ø
High speed draft
On, Off
Input buffer
On, Off
Beeper
On, Off
Auto CR*
On, Off
I.B.M. character table*
table 2, table 1
Note:
* Auto CR and I.B.M. character table are available only when IBM 2380/2381 Plus emulation is selected.
Default Settings (Mode 2)
Refer to the following flowchart and its accompanying table to adjust the default settings in mode 2.
START
The language selection menu
prints.
Change the language?
YES
NO
The default settings menu and
selection guide are printed.
Turn the printer off to save the
settings.
END
Push the
Tear off/Bin
switch
to select the default setting
you wish to change.
Push the
Load /Eject
switch
to change the setting's value.
Hold down the
Tear off/Bin
and
LF/FF
switches and turn on the printer.
Push the
Load/Eject
switch to
select a different language.
Push the
Tear off/Bin
switch.
Finished?
NO
YES
Figure 1-10. Changing Default Settings (Mode 2)