User`s guide

Appendix C:Accessing Network Printers
50 - PShop User’s Guide
These local queue’s interface script differs from the normal interface scripts in
that instead of running vvprint to print to the printer directly, vvprint is run to
create an output file (in the protocol designated in the .id file). This temporary
file is then submitted automatically with a new lp/lpr command into remote
queue. Remote queues may be those of either JetAdmin (for JetDirect printers),
Lantronix, or the UNIX system (for TCP/IP printers).
Networked Printer Installation Instructions
TCP/IP:
This configuration is completely automated in ps_install, including the creation
of the transport print queue. Please refer to “Configuring Your Printer” on
page xvii for information about performing the installation.
HP JetDirect / JetAdmin:
Set up the JetAdmin software and make sure it tests out OK. Send it a test print
to confirm proper operation. Then use ps_install as documented in “Configuring
Your Printer” on page xvii for information about performing the installation to
print the remote queue you’ve created with JetAdmin.
Lantronix RTEL:
Set up the RTEL software and make sure it tests out OK. Send it a test print to
confirm proper operation. Then use ps_install as documented in “Configuring
Your Printer” on page xvii for information about performing the installation to
print the remote queue you’ve created with RTEL. The URL that is current as of
the time of this writing to download RTEL is:
ftp://ftp.lantronix.com/pub/rtel/v4.2.2/sol_bin.tar