Specifications

EPL-5700 Chapter4 Disassembly and Assembly
Rev. A
4-2
6
4.2.20 High Voltage Board Removal
1. Remove the right cover. (See section .4. 2.2)
2. Remove the paper empty sensor. (See section 4.2.4)
3. Remove the control panel. (See section 4.2.6)
4. Remove the front cover. (See section 4.2.7)
5. Remove the shield cover of the main control board. (See section 4.2.9)
6. Remove the left cover.(See section 4.2.10)
7. Remove the top cover. (See section 4.2.14)
8. Remove the rear cover. (See section 4.2.15)
9. Remove the power unit. (See section 4.2.19)
10. Remove the harness coming out of the main control board from the
connector of the high voltage board.
11. Remove two CBB screws(3x8) securing the high voltage board to the
transfer unit.
12. Remove the high voltage board and earth plate.
CHECK POINT
9
When installing the high voltage board, install the
earth plate between high voltage board and
transfer unit.
CBB(3x8)
High Voltage Board
Transfer Unit
Earth Plate
High Voltage Board
Figure 4-35. High Voltage Board Removal