Specifications

EPL-5700 Chapter4 Disassembly and Assembly
Rev. A
4-1
3
4.2.11 Print Head Unit Removal
1. Remove the right cover.(See section 4.2.2)
2. Remove the paper empty sensor.(See section 4.2.4)
3. Remove the control panel. (See section 4.2.6)
4. Remove the front cover.(See section 4.2.7)
5. Remove the left cover. (See section 4.2.10)
6. Remove the shield cover of the main control board. (See section 4.2.9)
7. Remove the harness of the print head unit from CN205 and CN209 on
the board.
8. Remove one CSB screw(3x8) and four CS screws(3x6) securing the print
head unit to the printer.
9. Remove the harness from two clamps, which are securing the harness to
the printer, and remove the print head unit.
CHECK POINT
9
If you need to remove the fixing screw located at
the bottom of the print head unit(two CS screws),
insert the driver shaft from the holes located both
right and left sides.
CS(3x6)
Print Head
CSB(3x8)
CS(3x6)
Hole to insert
driver shaft
Hole to insert
driver shaft
Figure 4-17. Print Head Unit Removal