Specifications

EPL-5700 Chapter4 Disassembly and Assembly
Rev. A
4-
9
4.2.7 Front Cover Removal
1. Remove the right cover.(See section. 4.2.2)
2. Remove the control panel. (Refer to section.4.2.6)
3. Remove one CS screw(3x8) securing the front cover to the shield cover
of the main control board.
Upper Ed
g
e Hooks at Front Cover
Front Cover
CS(3x8)
Figure 4-11. Fixing Screws at the Front Cover
4. Release two lower edge hooks(one is located right bottom side, the other
is located left bottom) securing the front cover to the printer mechanism
by inserting the shaft of the driver from the holes, which are for installing
the optional second paper feed unit, and remove the front cover from the
bottom side.
Left Ed
g
e Hook
Ri
g
ht Ed
g
e Hook
Holes for installin
g
the second paper feed
unit
Figure 4-12. Lower Edge Hooks of the Front Cover
CHECK POINT
9
When installing the front cover to the printer, first,
hand the upper hooks of the front cover on the
mechanism, and install two lower hooks of the
cover to the mechanism.