Specifications

EPL-5700 Chapter4 Disassembly and Assembly
Rev. A
4-
6
4.2.3 Paper Feed Roller Removal
1. Open the paper feed roller cover.
2. Remove one CP(O) screw(3x8) securing the paper feed roller to the
shaft.
3. Remove the paper feed roller.
Print Head
CP(O) (3x8)
Paper Feed Roller Cover
Paper Feed Roller
Figure 4-5. Paper Feed Roller Removal
CHECK POINT
9
When installing the paper feed roller, tighten the
screw after checking the pin on the roller back
side is in the hole of the shaft.
4.2.4 Paper Empty Sensor Removal(PE1)
1. Release the hook connecting the paper feed roller cover and the printer,
opening the paper feed roller cover, and remove it, sliding it to the left
side.
2. Release the hook securing the paper empty sensor to the mechanism
frame of the printer, and remove it upward.
3. Remove the sensor harness from the paper empty sensor.
CHECK POINT
9
When installing the paper feed roller cover, install
the spring as it is shown in figure4-6.
Paper Empty Sensor
Spring
Paper Feed Roller Cover
Hook of the Paper Feed
Roller Cover
Figure 4-6. Paper Empty Sensor Removal