Specifications

EPL-5700 Chapter3 Troubleshooting
Rev. A
3-
6
3.3.1.3 “Warning” Conditions
Here explains warning conditions and how to cancel it. Even if warning
conditions occur, they do not effect on the printer’s operation.
Check Paper Size
The paper size setting is different from the size loaded in the printer. Check
to see if the correct size of paper is loaded in the tray, then,
Press Continue switch.
Perform reset or warm boot.
Note) If “Size Ignore” is On in the printer driver, this warning does not occur.
This printer detects paper length for paper size. Therefore, following paper
might not be able to detect its size difference.
Table 3-7. Mistakable Papers
Type Paper Size Paper
Length(mm)
Mistakable paper size
A4 297 LT
Regular A5 210 MON, HLT, DL
Paper JIS-B5 257 GLT, EXE, I-B5, C10
LT 294(11”) GLT, EXE, A4
HLT 215.9(8.5”) DL, A5, C5
LGL 355.6(14”) ---
EXE 266.7(10.5”) LT, GLT, JIS-B5, I-B5
GLG 330.2(13”) F4
GLT 266.7(10.5”) LT, EXE, JIS-B5, I-B5
F4 330 GLG
3x5” 127(5”) ---
Post Card 148 ---
MON 190.5(7-1/2”) A5
Special C10 241.3(9-1/21”) C5, JIS-B5, I-B5
Paper DL 220 HLT, C5, A5
C5 229 C10, HLT, DL
C6 162 ---
I-B5 250 GLT, EXE, JIS-B5, C10
Toner Low
The printer is almost out of toner or the toner left level reaches “0”, and
printing will be stopped. This error is canceled by pressing Continue switch.
Exchange with new toner and close the top cover. Pressing Continue
switch resets the toner counter automatically. However, even if you
don’t replace with a new toner and press Continue switch after closing
the top cover, the toner counter is reset.
Image Optimum
The printer can not print at the requested quality level because of insufficient
memory, and the printer reduces the quality automatically so that the printer
can continue printing.
Add more memory, or set Print Quality to 300 dpi and Page Protect to
Off temporarily in the printer driver.
Press “Continue” switch on the panel to cancel this warning indication.
Need Memory
The printer has insufficient memory available for the current task.
Add more memory to the printer.
Press “Continue” switch on the control panel to cancel this indication.
•If the printer escape from this warning during the data processing,
perform reset or warm boot.