Service manual

SERVICE MANUAL MASTER FILE
ENGLISH
Rev. A (1997/05/07)
5-5
7• The carriage width select menu appears. Move the cursor using «↑» or «↓» key to select «
(1)
80 column
» and press «
Return
» key.
8• The main menu appears. Move the cursor using «↑» or «↓» key to select «
(2) FF paper
» from
the list and press «
Return
» key. The test pattern printing starts.
9• After the test pattern is printed out, turn off the printer once to install the factory setting into the
EEPROM.
9• Press «
ESC
» key several times to quite the program.
CAUTION
As this adjustment program is just same as the check program in the
factory and includes many other check items which are not needed
for service, you should not performed any items which are not
described in this manual. Otherwise, the printer functions are not
guaranteed.
The factory setting value is not installed into the EEPROM without
this FF paper printing.
Program : xxxxx Setting:
9 pins VR 0 = x VR 1 = x VR 2 = x
** In line**
[ Carriage Width ]
>(1) 80 column
(2) 106 column
(3) 136 column
Program : xxxxx Setting:
9 pins VR 0 = x VR 1 = x VR 2 = x
** In line**
[ Main Menu ]
(1) Bi-D Adjust (6) Envelope
>(2)FF paper (7) – SUB MENU
(3) ---- N/A ----