Service manual

SERVICE MANUAL MASTER FILE
ENGLISH
Rev. A (1997/05/07)
5-4
.2.2 Factory Setting
The factory settings of the printer for each destination are installed in the EEPROM on the main
board. Therefore, If you have replaced the main board, you must re-install them again by the
adjustment program. This section describes how to install the factory settings:
1• Connect the printer and the host DOS/V computer with a parallel interface cable.
1• Set the 10 inch width continuous paper to the printer.
1• Run the adjustment program in the host computer.
1• The printhead wire select menu appears. Move the cursor using « ↑ « or » ↓" key to select
« 9 pins» from the list and press «
Return»
key.
5• Then the market setting menu appears. Referring to the market list table, move the cursor
using «↑" or «↓" key to select your market from the list and press «
Return
» key. To change
the choice to the other market after selection, you may press «
ESC
» key only. The market
setting menu appears again. An example (for EAI) is shown below:
Table 5-3. Market List
Destination Code Destination Code
EAI, EAI (Latin) USASTD EDG (NLSP) NLSP
EURO, EDG, EUL, EUL
(SCANDINAVIA), EFS,
EIS, EIB
EURSTD EUL (MIDDLE EAST),
EAL, ESP, EHK
DEFSTD
6• The process selection menu appears. Move the cursor using «↑" or «↓" key to select «
In line
»
and press «
Return
» key.
Program : xxxxx Setting:
VR 0 = x VR 1 = x VR 2 = x
** **
[ Printer setting ]
>(1) 9 pins
(2) 24 pins
Program : xxxxx Setting:
9 pins VR 0 = x VR 1 = x VR 2 = x
** **
[ Setting File ]
(1) DEFSTD (6) ITALIC
>(2) USASTD
(3) EURSTD
(4) NLSP
(5) RUSSIAN
Program : xxxxx Setting:
9 pins VR 0 = x VR 1 = x VR 2 = x
** **
[ Process select ]
>(1) In line
(2) Out-Going