Service manual

SERVICE MANUAL MASTER FILE
ENGLISH
Rev. A (1997/05/07)
5-1
.1 ADJUSTMENT OVERVIEW
.1.1 Required Adjustment
This section describes what adjustments are required after any part is removed or replaced. The
following table shows the relationship between the repair item and the adjustment.
Table 5-1. Required Adjustment
Required Adjustment Platen Gap Factory Setting Bi-D
Adjustment
Printhead Removal or
Replacement
---
Printer Mechanism Replacement --- ---
Printer Mechanism Removal ---
Main Boar Replacement ---
Timing Belt Replacement ---
Platen Replacement --- ---
Carriage Assembly
Replacement
---
CR Motor Replacement --- ---
EEPROM Clear --- ---
Note 1) « " means adjustment is required.
Note 2) «---« means adjustment is not required.
.1.2 Adjustment Tools
The following table shows the tools required for each adjustment.
Table 5-2. Required Adjustment Tool
Adjustment Required Tool
Platen Gap Thickness gauge
Factory Setting Setting a diskette
Bi-D Adjustment Setting a diskette