Service manual

SERVICE MANUAL MASTER FILE
ENGLISH
Rev. A (1997/05/07)
4-17
.2.10.3 PF Gear Train Disassembly
1• Remove the printer mechanism. (See Section 4.2.9.)
1• Remove the CR motor. (See Section 4.2.10.1.)
1• Remove the PF motor. (See Section 4.2.10.2)
1• Remove the head FFC from the FRAME,SUB,RIGHT of the printer mechanism.
1• Remove the 2 CBS (M3
×
8) screws securing the FRAME,SUB,RIGHT, and remove the
FRAME,SUB,RIGHT.
CAM ,CLUTCH,TRACTOR
FRAM E,SUB,RIGHT
CBS(3 x 8)
Head FFC
IN T E R M IT T E N T G E A R
LEVER, RELEASE
SPUR G EAR,34.5
SPUR G EAR,21
SPUR G EAR,34
SPUR G EAR,34.5
SPUR G EAR,34.5
SPUR G EAR,27
CO M PRESSION SPRING 200
Plain W asher
Figure 4-13. PF Gear Train Disassembly
CHECK POINT
Verify to properly mesh the release lever with the teeth of
INTERMITTEN GEAR as shown below;
IN TER M ITTEN T G EAR
LEVER,RELEASE
Figure 4-14.
Engagement between Release Lever and INTERMITTENT GEAR
Assembly to engage the hole of CAM,CLUTCH,TRACTOR with the
ejection part of the release lever.