Service manual

SERVICE MANUAL MASTER FILE
ENGLISH
Rev. A (1997/05/07)
4-15
.2.10 Printer Mechanism Disassembly
.2.10.1 CR Motor Removal
1• Release the tension spring.
1• Disengage the TIMING BELT from the CR motor pinion and hang it on the hook.
1• Remove 2 SHAFT,MOUNT,CR screws securing the CR motor assembly to the
FRAME,SUB,RIGHT, and remove the CR motor.
1• Remove 2 CB (M3
×
6) screws securing the CR motor to the motor bracket, and remove the
CR motor.
CR MotorSHAFT,M OUNT,CR
C B (M 3 x 6)
Tension S pring
Hook
Tim ig Belt
CR Motor Bracket
FRAM E,SUB,RIG HT
Figure 4-10. PF Motor Removal
If replace the CR motor or TIMING BELT, perform the Bi-d adjustment.
(See Chapter 5.)
CHECK POINT
Position the CR motor assembly on the CR motor bracket correctly as
shown below;
M o to r H a rn e s s
CR Motor Bracket
CR Motor
Figure 4-11. Positioning the CR Motor on the CR Motor Bracket