Service manual

SERVICE MANUAL MASTER FILE

ENGLISH

Rev. A (1997/05/07)

4-13

.2.8 Platen Removal

1• Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover, knob and

tractor unit. (See Section 4.2.3.)

1• Remove the upper housing. (See Section 4.2.4.)

1• Remove 2 CBS (M3

8) screws securing the COVER,PLATEN.

1• Rotating the teeth of the PLATEN SHAFT HOLDERs toward front, disengage them from the

Left/Right Side Frames.

1• Slide the PLATEN toward right a little and take it off upward.

If replace the plate, perform the platen gap adjustment. (Refer to

Chapter 5.)

CBS(M 3 x 8)

C over P laten

PLATEN

PLATEN SHAFT HOLDER

Left S ide Fram e

R ight S ide Fram e

Figure 4-8. Platen Removal