Service manual

SERVICE MANUAL MASTER FILE

ENGLISH

Rev. A (1997/05/07)

4-8

.2.4 Upper Housing Removal

1• Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover, knob and

tractor unit. (See Section 4.2.3.)

1• Remove 2 CBS (M3

6) screws and a CBB (4

12) screw securing the upper housing to the

lower case.

1• Set the release lever to friction paper feeding.

1• Opening the front side of upper housing a little, disconnect the Panel FFC from the connector

of panel assembly.

1• Opening the front side of upper housing a little, release 2 hooks of panel assembly attaching

to upper housing from front bottom side of upper housing and remove the panel away.

1• Open the upper housing from front side, and remove it away.

Upper Housing

R elease Lever

SHEET,RELASE,CAP

CBB(4 x 12)

CBS(M 3 x 6)

Panel A ssem bly

Low er C ase

Panel FFC

CBS(M 3 x 6)

Figure 4-5. Upper Housing Removal

CAUTION

When assembly the upper housing, put the hooks of the upper

housing on the catching holes in rear side of the lower case at first

and close the housing.

Panel assembly is put on the upper housing after upper housing

assembled.

Sheet, Release, Cap is able to be assembled after upper housing

assembly.