Specifications

REV.-B
3.2.5.2 Removing the MOTOR, PF
1. Remove the PRINTER MECHANISM from the HOUSING
ASSY., LOWER(see Section 3.2.4).
2. Remove the COMPRESSION SPRING, 200 that holds the platen shaft.
3. Release the two clips holding the MOTOR,
PF to the FRAME, MAIN, RIGHT.
4. Remove the MOTOR,
PF from the FRAME, MAIN, RIGHT.
FRAME, MAIN, RIGHT
.
MOTO’R, PF
Figure 3-12. Removing the MOTOR, PF
Point to Note for Assembly
See Section 3.2.5.13 for details on arranging and positioning the motor cable.
3.2.5.3 Removing the
FFC (CABLE, HEAD, FRONT(,REAR))
1.
2.
3.
4.
5.
Remove the printhead (see Section 3.2. 1).
Remove the PRINTER MECHANISM from the HOUSING
ASSY., LOWER (see Section 3.2.4).
Remove the
FFC from the clips that hold it along the rear side of the PRINTER MECHANISM. Make
sure that the
FFC is free.
Remove the
FFC from clip on the HOLDING PLATE, FFC at the rear of the PRINTER MECHANISM.
Remove the four clips that hold the HOLDING PLATE, FFC to the base frame. Remove the FFC together
with the HOLDING PLATE, FFC.
.
.
L(
CABLE, HEAD, FRONT
CABLE, HEAD, REAR
I
Figure 3-13. Removing the FFC Cable
Point to Note for Assembly
See Section 3.2.5.13 for details on arranging and positioning the
FFC.
3-11