Specifications

REV.-B
I
Point to Note for Assembly and Adjustment
After replacing the BOARD ASSY., MAIN, you must adjust the bidirectional print position
again to ensure bidirectional printing is correctly aligned (see Section 4.2).
3.2.3.2 Removing the BOARD
ASSY., POWER SUPPLY (C062 PSB/PSE Board)
1. Remove the HOUSING
ASSY., UPPER (see Section 3.2.2.2).
2. Remove the cable for connector CN 13 from the BOARD
ASSY., MAIN,
3. Remove the cable for connector
CN 1 from the BOARD ASSY., POWER SUPPLY.
4. Remove the four
CBB(C) (M3X 10) screws and the CB (M3X8) screws that hold the BOARD ASSY.,
POWER SUPPLY to the HOUSING
ASSY., LOWER. Remove the BOARD ASSY., POWER SUPPLY.
BOARD ASSY., POWER SUPPLY (C062 PSB/PSE Board)
GROUNDING WIRE
(* 136-column only)
(80-column)
(1 36-column)
Figure 3-8. Removing the BOARD ASSY., POWER SUPPLY
I 3.2.3.3 Removing the BOARD ASSY., PANEL (C062 PNL Board)
1. Remove the HOUSING, FRONT (see Section 3.2.2.1).
2. Remove the 10
CBB(C)(M3X 10) screws that hold the BOARD ASSY.,PANELto the HOUSING, FRONT.
Remove the BOARD
ASSY., PANEL.
, PANEL
ard)
HOUSING,
FRONT
Figure 3-9. Removing the BOARD ASSY., PANEL
3-8