Specifications

REV.-B
3.2.2 Removing the Printer Case
This section describes how to remove the front case and HOUSING ASSY., UPPER.
3.2.2.1 Removing the
HOUING, FRONT
1. Remove the COVER
ASSY., PRINTER, FRONT.
2. Remove the HOUSING, FRONT.
3. Use a screwdriver to release the clips that hold the front case to the HOUSING
ASSY., UPPER. Open
the HOUSING, FRONT. Remove connector
CN 1 on the BOARD ASSY., PANEL (C062 PNL). Remove
the HOUSING, FRONT.
picture
printer)
I
Figure 3-4. Removing the HOUSING, FRONT
shows an 80-
1
3.2.2.2 Removing the HOUSING ASSY., UPPER
1.
2.
3.
4.
5.
Remove the COVER ASSY., PRINTER, FRONT, the COVER ASSY., EJECT, the TRACTOR ASSY, and
the KNOB.
Remove the two CBS(C)
(M3 X 10) screws that hold the optional interface card cover. Remove the
cover.
CB8(C) ‘M4XX) ‘crew2
CBS(C) (M3X 10) Screws
COVER, CONNECTOR, UPPER
for Optional Interface Card
(*This picture is 80-column)
Figure 3-5. Removing the COVER, CONNECTOR, UPPER for the Optional Interface Card
Remove the HOUSING, FRONT (see Section 3.2.2. 1).
Remove the two
CBB(C) (M4 X 25) screws that hold the HOUSING ASSY., UPPER to the HOUSING
ASSY., LOWER.
Depress the two clips that hold the HOUSING
ASSY., UPPER to the FRAME ASSY., SHEET GUIDE.
Remove the HOUSING
ASSY., UPPER.
3-6