Specifications
REV.-A
Table 6-2. Lubrication Points (Refer to Figure 6-2)
Ref.
No.
Lubrication Points
1
l/4
of the perimeter of the top edge of the gear (8.5 mm, 30 mm)
2
l/3
of the perimeter of the top edge of the gear (40 mm)
3
l/3
of the perimeter of the top edge of the platen gear
4
Portion of carriage that contacts base frame
5
Oil pad
6
Portion of platen shaft that contacts ground spring
7
Gear (40 mm) shaft
8
Gear (8.5, 30 mm) shaft
9
Ribbon-feed gear shafts
10 Gear (1 1.5 mm) shaft
11
Portion of paper guide that contacts gear (18 mm)
12
Portion of paper guide that contacts sub paper guide
13
Portion of release shaft that contacts paper guide
14
Portion of paper tension roller shaft that contacts paper tension frame
15
Portion of tractor shaft that contacts tractor frame (left)
16
Tractor clutch cam
NOTE: Lubrication must be applied during the reassembly process.
Lubricant
G-26
G-26
G-26
G-26
o-2
G-20
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-26
Table 6-3. Adhesive Application Point (Refer
tq
Figure S-l.)
I
Adhesive
Application
Point
)
No.
of Points
Portion
where
timing
belt engages
the
carriage
1
Figure 6-l. Correct Adhesive Application
6-2