Specifications

REV.-B
9. Rotate the adjusting bushing until the platen gap is large enough for a thickness gauge of 0.44
mm thickness but too narrow for one of 0.47 mm thickness.
0.45 mm
.I
/-
PLATEN
Printhead
f/
Figure 4-4. Platen Gap
10. Move the carriage until the edge of the printhead is at the 75th column print position.
1 1. Use the box driver (7 mm) to rotate the adjusting bushing on the FRAME, MAIN, RIGHT of the
PRINTER MECHANISM.
12. Rotate the adjusting bushing until the platen gap is large enough for a thickness gauge of 0.44
mm thickness but too narrow for one of 0.47 mm thickness.
13. Move the printhead back again so that the edge of the printhead is at the 5th column print position.
Check the platen gap again with the thickness gauge. It should still be large enough for a thickness
gauge of 0.44 mm thickness but too narrow for one of 0.47 mm thickness. If this is not the case,
go back to step 8.
14. Center the carriage. Check the platen gap again with the thickness gauge. It should still be large
enough for a thickness gauge of 0.44 mm thickness but too narrow for one of 0.47 mm thickness.
If this is not the case, go back to step 8.
15. Remove the printhead, install the RIBBON MASK and then replace the printhead.
4-3