Specifications

REV.-B
3.2.5.2 Removing the MOTOR, PF
1. Remove the PRINTER MECHANISM from the HOUSING ASSY., LOWER (see Section 3.2.4).
2. Remove the COMPRESSION SPRING, 200 that holds the platen shaft.
3. Release the two clips holding the MOTOR, PF to the FRAME, MAIN, RIGHT.
4. Remove the MOTOR, PF from the FRAME, MAIN, RIGHT.
FRAME, MAIN, RIGHT
MOTOR, PF
Figure 3-12. Removing the MOTOR, PF
Point to Note for Assembly
See Section 3.2.5.13 for details on arranging and positioning the motor cable.
3.2.5.3 Removing the FFC (CABLE, HEAD, FRONT (,REAR))
1. Remove the printhead (see Section 3.2.1).
2. Remove the PRINTER MECHANISM from the HOUSING ASSY., LOWER (see Section 3.2.4).
3. Remove the FFC from the clips that hold it along the rear side of the PRINTER MECHANISM. Make
sure that the FFC is free.
4. Remove the FFC from clip on the HOLDING PLATE, FFC at the rear of the PRINTER MECHANISM.
5. Remove the four clips that hold the HOLDING PLATE, FFC to the base frame. Remove the FFC together
with the HOLDING PLATE, FFC.
CABLE, HEAD, FRONT
CABLE, HEAD, REAR
Figure 3-13. Removing the FFC Cable
Point to Note for Assembly
See Section 3.2.5.13 for details on arranging and positioning the FFC.
3-11