Specifications

1.2 SPECIFICATIONS
This section provides specifications for the LQ-570/1070 printer.
1.2.1 Hardware Specifications
Printing method Serial, impact, dot matrix
Pin configuration 24 wires (12 X 2 staggered, diameter 0.2 mm)
Feeding methods
Line spacing
Paper insertion
Paper-feed speed
Figure 1-2. Pin Configuration
Friction feed (front/top)
Push tractor feed (rear)
Pull tractor feed (front/bottom)
Push-pull tractor feed (with optional tractor) (rear)
1/6 inch, 1/8, or programmable in units of 1/360 inch
Friction feed
Front or rear side
Tractor feed
Front, bottom, or rear side
Friction without CSF
77.6 msec (l/6-inch feed)
2.2 inches per second (ips) (continuous)
Friction with CSF
77.6 msec (l/6-inch feed)
2.2 ips (continuous)
Tractor
77.6 msec (l/g-inch feed)
2.2 ips (continuous)
NOTE: The points below provide precautions for handling paper.
REV.-B
1. Friction feed (release lever in FRICTION POSITION).
0 Paper must be loaded from the front or top entrance.
0 Do not use continuous paper.
0
Do not perform any reverse paper feeds within the top 8.5 mm (.34 in.), bottom 22 mm (87 in.)
(top entrance), or bottom 40.2mm (1.6 in.) (front entrance) area.
0 Do not perform reverse feeds greater than l/6 inch after a paper end has been detected.
1-3