Specifications

REV.-B
● Use the paper tension unit.
● Do not use multi-part cut-sheet forms, except with front insertion.
● Do not perform reverse feeds greater than 1/6 inch when using envelopes.
2. Push tractor feed (release lever in REAR PUSH POSITION).
Paper must be loaded from the rear entrance.
Release the friction-feed mechanism.
Multi-part forms must be spot pasted beyond the perforation between the tractor holes.
Paper for multiple copies must be carbonless multi-part paper.
Use the paper tension unit.
Do not perform reverse feeds greater than 4/15 inch.
Since accuracy of paper feed cannot be assured after the paper end has been detected, please
do not perform reverse feeds after detection of a paper end.
3. Push-pull tractor feed (release lever in REAR PUSH POSITION).
Paper must be loaded from the front, rear, or bottom entrance.
Release the friction-feed mechanism.
Remove the paper tension unit and attach the pull tractor unit.
Ensure that there is no slack in the paper between the platen and the pull tractor.
Precisely adjust the horizontal position of the pull tractor and push tractor sprockets.
Paper for multiple copies must be spot pasted beyond the perforation between the tractor holes.
Paper for copies must be a carbonless multi-part paper.
Do not perform reverse feeds greater than 4/15 inch.
Do not perform reverse feeds after the paper end has been detected.
4. Pull tractor feed (release lever in PULL POSITION).
●
●
●
●
●
●
●
Paper must be loaded from the front or rear entrance.
Release the friction-feed mechanism.
Remove the paper tension unit and attach the pull tractor unit.
Insert the paper from either front or bottom.
Paper for multiple copies must be spot pasted beyond the perforation between the tractor holes.
Paper for copies must be a carbonless multi-part paper.
Do not perform reverse feeds.
Paper specifications See tables 1-3, 1-4, 1-5, 1-6, and 1-7
Table 1-3.
S~ecifications for Cut Sheets (One-Part Paper)
Width
Length
Thickness
Weight
Quality
148 mm to 257
(’420) mm (5.8 in. to 10.1 (* 16.5) in.)
(top insertion)
182 mm to 257 (*364) mm (7.2 in. to 10.1 (* 16.5) in.)
(front insertion)
364 mm (1 4.3 in.), maximum
0.065 mm to 0.14 mm (0.0025 in. to 0.0055 in.)
14 lb. to 24 lb. (52.3
g/m2 to 90 g/m2)
Standard paper (photocopier paper, etc.)
Recycled paper (at normal temperatures)
(*136-column)
1-4