Specifications

REV.-A
Table 6-2. Lubrication Points (Refer to Figure 6-2)
Ref. No. Lubrication Points
Lubricant
1
1/4 of the perimeter of the top edge of the gear (8.5 mm, 30 mm)
G-26
2
1/3 of the perimeter of the top edge of the gear (40 mm)
G-26
3
1/3 of the perimeter of the top edge of the platen gear
G-26
4
Portion of carriage that contacts base frame
G-26
5 Oil pad
o-2
6
Portion of platen shaft that contacts ground spring
G-20
7
Gear (40 mm) shaft
G-26
8 Gear (8.5, 30 mm) shaft
G-26
9
Ribbon-feed gear shafts
G-26
10 Gear (1 1.5 mm) shaft
G-26
11
Portion of paper guide that contacts gear (18 mm)
G-26
12
Portion of paper guide that contacts sub paper guide
G-26
13 Portion of release shaft that contacts paper guide
G-26
14
Portion of paper tension roller shaft that contacts paper tension frame
G-26
15 Portion of tractor shaft that contacts tractor frame (left)
G-26
16
Tractor clutch cam
G-26
NOTE: Lubrication must be applied during the reassembly process.
Table 6-3. Adhesive Application Point (Refer to Figure 6-l.)
Adhesive Application Point
No. of Points
Portion where timing belt engages the
1
carriage
Figure 6-1. Correct Adhesive Application
6-2