Service manual

EPSON Stylus &2/25 1520
Rev. A
3-1
2
3.2.7 PSB/PSE Board Assembly Removal
1. Remove the upper housing. (Refer to Section 3.2.1.)
2. Remove the printer mechanism unit. (Refer to Section 3.2.6.)
3. Disconnect the power cable connector from CN1, and the C211 MAIN board connector cable from the
CN2.
4. Remove 4 screws (CBP, 3X12) securing the PSB/PSE Board to the lower housing, and remove the
PSB/PSE Board.
;
Make sure that the AC power cable is unplugged before disconnecting the power cable connector.
WARNING
Screws (CBP 3X12)
PSB/PSE Board
CN1
CN2
Lower Housing
Figure 3-9. PSB/PSE Board Removal