Service manual

Product Description
Rev. A
11
1.2.7 Adjust Lever
The adjust lever , located at the left and upper side of the printer , is used to adjust the gap between the
paper and platen. The adjust lever must be set to the proper position the paper type in order to prevent the
paper from smudging.
Paper
Type
Lever
Position
Platen Gap Adjustment
Value
Cut sheet
Transparency
Continuous paper
Index card
Far side (0) 0 mm
Envelopes Near side (+) + 0.7 mm
Table 0-12. Adjust Lever Position
0
+
Adjust lever
Figure 0-6. Adjust Lever Settings