Service manual

Adjustment
Rev. A
4-1
4.1 Overview
This section describes adjustmenta required after disassembling and assembling the printer.
;
Adjustment must be performed in the order numbered in Table 4-1.
; Be sure to leave the ink cartridges installed in the CR unit when returning the printer to the
customer.
; Use 720 dpi exclusive paper when printing the adjustment pattern.
Replaced Unit/Part Adjustment Menu
Replacement of the printer
mechanism or
MAIN board
1. EEPROM Clear (Refer to Section 1.4.3.)
2. Head Voltage Write
3. BK-M Hight Adjustment
4. Head Gap Adjustment
5. Bi-d Adjustment
Black head replacement
1. Head VH voltage input
2. Black Head Angular Adjustment
3. BK-M Hight Adjustment
4. Head Gap Adjustment
Black head removal
1. Black Head Angular Adjustment
2. BK-M Hight Adjustment
3. Head Gap Adjustment
Color head replacement
1. Head VH voltage input
2. Color Head Angular Adjustment
3. BK-M Hight Adjustment
4. Head Gap Adjustment
Color head removal
1. Color Head Angular Adjustment
2. BK-M Hight Adjustment
3. Head Gap Adjustment
CR unit Replacement
1. Platen Gap adjustment
2. Head Voltage Write
3. Bi-d Adjustment
CR unit removal or CR unit
disassembling
1. Platen Gap adjustment
2. Bi-d Adjustment
CR motor removal or CR
motor disassembling
1. Bi-d Adjustment
Note) The adjusting program doesn’t run without inputting the customer data first.
CAUTION
Table 4- 1 Required Adjustment