User`s manual

3-19
The next display (the last display in the program) is:
O
“CYCL” in this display means that the type of program you have
set up is a CYCL program. “#???” means that the program
doesn’t have a program number yet since it hasn’t been stored.
Store the program following the procedure on the next page. This
will allow you to run the program you have customized at any
time in the future without needing to set it up again.
O
CYCL#??? xx.xC
R
UN-STORE-PRINT-HOME
Program Number not yet assigned
Program Type
CYCL