User`s manual

3-15
Defining Values for Setpoint # 1
In the following steps, you will change some of the default values
for Setpoint #1.
1
Look for the cursor on the display. It appears under the ramp time.
The default time of 0:00 is most commonly used. This causes the
sample to be heated or cooled to the target temperature as fast as
possible.
2
For this example, we will not change the default ramp time. Press
ENTER
to accept 0:00 minutes.
The cursor moves to the temperature entry.
3
Change the temperature to 96.5 degrees C. Press
9
, then
6
, then
5
.
If you make a mistake, press
CE
(Clear Entry) to erase the value,
then start again. When the value is correct, press
ENTER
.
Note that the temperature is set to the nearest tenth of a degree. To
enter a whole number such as 94 degrees C, you must specify 94.0
(press
9
, then
4
, then
0
).
Setpt #1 Ramp 0:00
94.0C Hold 0:30
Setpt #1 Ramp 0:00
94.0
C Hold 0:30